Pull out and push in the charger- cleaning tool several times. Grasp both sides of the staple cartridge, lift up the staple cartridge, and then pull it out. This symbol warns against dismantling the device. Dust remover Collects the dust generated in the copier. Placed on February 9,

Uploader: Fegar
Date Added: 10 September 2013
File Size: 31.30 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 95777
Price: Free* [*Free Regsitration Required]

Select the desired paper setting. Touch [A3 wide paper size]. Note Slowly remove the tape attached to the toner cartridge. Page 71 – To set the “2 in 1, 4 in 1, Booklet Copy Carefully pull out any documents.

Select the ID for the desired account. Page Move the guide back to its original position. Page Page – To clear a paper misfeed in the manual b Note Be sure to remove two staples, otherwise stapling cannot continue correctly.

Administrator Mode Operations Refer to p. Imaging unit release lever Used to install and replace the imaging unit.

Our fast free shipping services will guarantee full satisfaction on ink cartridges and toners you need. Would highly recommend to others.


Konica Minolta 8031 Instruction Manual

Don’t have an account? Legal Restrictions On Copying Copyrighted works without permission of the copyright owner You are prohibited under any circumstances to copy domestic or foreign currencies, or works of art without permission of the copyright owner.

Page 11 in. Select the desired language. By pressing ‘print’ button you will print only current page. Close the duplex unit door. Close the right-side door of the large capacity tray.

Page A paper misfeed in the large capacity tray p. Supplies And Parts Filter Collects the toner dust generated in the copier. Page Open the upper door of the finisher, and then pull out any paper in the feed section.

Konica printing

To Set The “auto Reset” Function between 1 and 9 minutes. Function Combination Table 8.

Touching displays accounts through The test pattern is printed on the A3-size paper. Note If stapling still cannot be performed, even after performing the above procedure, contact your authorized service representative.


We will not share your information with anyone. Using Copy Programs To check the specified settings of a program Touch [Check], and then touch the number of the program that you wish to konics. If any caution labels or caution indicator is soiled, please clean to make legible. Note Only use toner that has been manufactured specifically for this copier.


To Set The “auto-select Paper For Small Original” Function In this case, since the document size cannot be detected and the paper cannot be automatically selected, the paper source must be selected. Indicates that the paper is empty. Turn knobs FN5 clockwise at the same time.