GODEX EZ-1200P DRIVER DOWNLOAD

When printing, ribbon must be installed to transfer the print contents onto the media. Supplies are warranted to be free from defect in material and workmanship for a period of six 6 months for media and twelve 12 months for ribbon from the date of shipment by Godex. Cutter Parts one is for stripper installation, another is for cutter installation , before plug the connector into socket, please check the pin first. Power on the printer after clearing the paper jam, the cutter will return to the correct position automatically. Once the USB cable is connected from PC to the printer, PC will automatically detect the new device and begin the installation process. Stripper Installation Diagram Maintenance And Adjustment Note:

Uploader: Faejin
Date Added: 18 October 2016
File Size: 31.7 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 97822
Price: Free* [*Free Regsitration Required]

Place the label roll onto the Label Roll Core, Loosen and lift the upper print mechanism by pressing the locking tensons.

Page 24 Clip in the yodex side of the cutter module 29 first,then secure the left side. DB9 female, pin assignment is as follows: Don’t show me this message again. Page of 32 Go.

Please power off the printer before installing the stripper module. This warranty becomes void if the item is modified improperly installed, handled or used, or damaged by accident or neglect.

  CABLES UNLIMITED USB 2.0 TO DB9M SERIAL ADAPTER DRIVER DOWNLOAD

Check the pins where the memory is to be connected to, then plug the memory card onto the mainboard. Extended Memory Parts Printer Installation Chapter 2 – Printer Installation This printer model has the following print modes: Label gap, vodex mark, and punch hole sensing.

Direct thermal label printer Godex EZ-1200+

Table Of Contents 1. Page 4 defects in material and workmanship for 90 days except where otherwise denoted from date of invoice.

Warranty Information All Godex products are sold with warranties. Led Message Description When printing with continuous media, when pressing the Feed key, the printer will feed media out to a certain length.

Open the top cover by pressing the Cover Open Buttons on both sides. Data Terminal Equipment Printer. Printer Options Installation 5. Take the power cable, plug the cable switch to the power socket, and then connect the other end of the cable to the printer power socket. Comments to this Manuals Your Name. Below is the general information: Select the location of the driver. Clip in the right side of the sz-1200p module 29 first,then secure the left side.

Godex EZ-1200

Please power off the printer before installing the extended memory. When printing, no ribbon is necessary; it only requires direct thermal media.

  LANIER LD175 PCL6 DRIVER DOWNLOAD

With plastic outer casing, the EZ series is designed to be a lightweight and a low cost printer for large variety of printing requirement.

All printers excluding printheads are warranted against defect in material or es-1200p for twelve 12 months from the invoice date.

Cutter Parts one is for stripper installation, another is for cutter installationbefore plug the connector into socket, please check the pin first. No other warranties, expressed or implied, are given. To print the manual completely, please, download it. Ez-120p the cutter module and lock it with the two side screws Page 21 Place the right side in first, and then fit the left side.

Godex EZ (free) – Download latest version in English on phpnuke

Data Terminal Equipment Printer Page Align the label guides to the lablel edge. Also See for EZ Programmer’s manual – 25 pages. Label Installation Open the top ez-1200. Flip the cutter module 29 down to open the cutter.