FUJITSU SCANNER M3093DG DRIVER DOWNLOAD

Is the scanner in the state of “Ready to operate”? Use the following procedure to make the scanner select one of the four product IDs: Please check the followings. Sensor location MGX Figure 2. There is not any problem with WindowsNT 4.

Uploader: Feshakar
Date Added: 16 June 2009
File Size: 70.98 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 42617
Price: Free* [*Free Regsitration Required]

Does your driver support your operating system?

Introduction of End of Life product “M3093DE/DG”.

Is the power of the scanner turned on before turning on the power of PC? Please check the followings. If the lamps are not turned on or off as shown in Table 1, repeat this step. However, the effective speed of this interface is 1MBPS.

Open the ADF cover all the way.

Manual Downloads: M3093DG

After confirming the lamps in step 2press the B5-size sensor again. Is the power of the scanner turned on?

Are the terminators of all devices set correctly? The transition status is recognized by the LEDs. This information is released as of December The most popular USB interface is called Version1. When using MD under Windowsa problem is reported that the endorser imprinter can not print correctly. Fujitsu fi Series Image Scanner Product.

  COMTREND 802.11G WIRELESS PC CARD DRIVER

Fujitsu fi Series Image Scanner Product

DILL using 16 bit version are not found. Changing product identification 4. We are confirming a detailed cause.

With Windows, it is reported that all FJ scanners have a problem when operating. Is the option board of the scanner installed correctly? Use the fuujitsu procedure to make the scanner select one of the four product IDs: Is the terminator set properly?

Contacts Related links Sitemap. Some causes are probable regarding this error message. Sensor location MGX Figure 2.

Probable trouble at scanner connection. There is not any problem with WindowsNT 4. Is the power cable of the scanner connected correctly and the scanner power turned on?

Please check the following items first. Is the scanner in the state of “Ready to operate”?

Software Downloads: MGX / MDG / MGX / MDC / MDC – Fujitsu Global

Turn the power on while pressing the OMR sensor. Is your diver of SCSI board installed correctly?

  MPN EN5038B DRIVER DOWNLOAD

The file has not been installed or have deleted. Is the scanner supported by the driver connected? When you stop pressing the OMR sensor, the lamps are turned on or off as shown in Table 1 according to the current ID. This message appears when the driver can not receive answers from the scanner. When the scahner enters ID change mode, the lamps are turned on or off as shown in Table 1 for the product ID change mode.