Press Enter to continue. If you do not press F6 while the prompt is being displayed, the screen allowing you to specify additional drivers is not displayed and the installation will fail. Ensure that the floppy. The Windows installation will format the boot disk and all data will be lost. You will need to restart the system and go back to Step 3. Otherwise, press Enter to select Express Setup. Note that if you are using the floppy disk local installation method, the JavaRConsole floppy drive or floppy image devices must not be redirected.
|Date Added:||7 April 2006|
|File Size:||18.31 Mb|
|Operating Systems:||Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X|
|Price:||Free* [*Free Regsitration Required]|
Make sure that you have completed all of the requirements listed in Installation Requirements.
Connect the floppy drive to the JavaRConsole system if necessary and insert the mass-storage drivers floppy disk into the rakd drive. At the Welcome to Setup screen, press Enter to continue.
Note – The prompt is displayed in the sss stages of Windows Setup and lasts for approximately five seconds and is easy to miss.
A screen appears listing the available drivers. Windows Setup lists the driver to be installed. Note – The complete Microsoft Windows operating system installation process is not documented in this section.
Adaptec – Adaptec SATA II RAID SA
Make sure that the mass storage drivers are accessible according to the mass storage driver installation method satw-ii you have selected. Make sure to reserve a minimum of MB of unpartitioned space at the end of the drive. The Windows installation will format the boot disk and all data will be lost.
You will need to restart the system and go back to Step 3. Press Enter to continue.
Windows Setup will then display your selection. To Install the Operating System. For requirements specific to the mass storage driver and Windows media delivery methods that you have chosen, see TABLE Press F6 when you see the following prompt at the bottom of the screen during the Windows Setup process: This chapter describes how to install the Windows Server operating system directly onto your server using the Windows Server media. When this wineows appears you will need raix complete one of the following steps, depending on which driver delivery method you have chosen, to complete the installation:.
This section documents only the steps that are specific for installing Windows Server on your server.
Select the appropriate mass storage controller driver version depending on the version of Windows bit or bit you are installing, and then press Enter:. If you do not press F6 while the prompt is being displayed, the screen allowing you to specify additional drivers is not displayed and the installation will fail. Ensure that the floppy. Before beginning the operating system installation, make sure that the following requirements are met.
If you created a RAID volume on your boot disk as part of your prerequisite preparations for installing Windows, press C to select Custom Setup and manually partition the disk. Select a setup mode Express or Custom and continue. Note that if you are using the floppy disk local installation method, the JavaRConsole floppy drive or floppy image devices must not be redirected. Press S to specify additional devices.
Supported_RAID-Controllers – smartmontools
Follow the on-screen instructions to complete the initial setup of Windows Server until you devicw prompted with the following message:. If prompted with Press any key to boot from CDquickly press any key. Otherwise, press Enter to select Express Setup.
Press any key to restart. Then, press any key to restart the system and complete the Windows Server Installation. Remove disks or other media. After pressing F6, a screen will appear providing you with the option to specify additional mass storage devices.
Follow these steps to install the Microsoft Windows Server software onto your your server. Install Windows Server